Litematica not working

[Hail]

For around a month or two, my litematica will just not work when I try to place a schematic. I can still area-select, but not place down a schematic. This is ONLY a problem for this server, it doesnt happen anywhere else.

Any help? (Blurmit and Endereyegames please see this post)

 

[InfernaI]

Check your Rendered Layers and make sure it isn't set to "single layer" or something else. This is a common mistake to make.

 

[Hail]

Check your Rendered Layers and make sure it isn't set to "single layer" or something else. This is a common mistake to make.

Nope, still not working.

 

[InfernaI]

Nope, still not working.

You most definitely have to have a setting saved for the Invaded Lands server (settings are saved per server) that is preventing you from seeing your litematica schematics. I recommend joining on "Survival.invadedlands.net" or "any.invadedlands.net" and give it a try again. If it shows up when you join through one of those either IPs, then its a setting. If not, you are going to have to delete litematica files and reset them.

 

[Hail]

You most definitely have to have a setting saved for the Invaded Lands server (settings are saved per server) that is preventing you from seeing your litematica schematics. I recommend joining on "Survival.invadedlands.net" or "any.invadedlands.net" and give it a try again. If it shows up when you join through one of those either IPs, then its a setting. If not, you are going to have to delete litematica files and reset them.

Thank you very much, I joined using survival.invadedlands.net and its working fine now

 

[InfernaI]

Thank you very much, I joined using survival.invadedlands.net and its working fine now

This confirms that you have a specific setting set for "InvadedLands.net" that is causing your schematics to not show up, Id recommend going through your settings finding which one it is, or deleting your litematica setting files to just completely reset it.